Users browsing this thread: 1 Guest(s)
PCSX2 Jak 3 Model Ripping Help
#1
Hello, I am trying to rip some more characters from Jak 3 as inspired by o0DemonBoy0o but I when I rip the model using PCSX2 0.9.8 and import the .OBJ in the snaps folder into Blender 2.8 it comes out looking like this: https://ibb.co/mtxYFvL[Image: mtxYFvL]

If someone is available to help me out it would be greatly appreciated.
Thank you

EDIT: Ok so I fixed the problem, just need to figure out how to get rid of the duplicate meshes since I captured the model while it was in motion.
Reply
Thanked by:


Messages In This Thread
PCSX2 Jak 3 Model Ripping Help - by ViceCase - 05-22-2020, 01:22 PM

Forum Jump: