|
3D Printing
|
|
08-23-2014, 08:43 PM
So, I fixed up the model for Kakuna from Pokémon Stadium 2 for 3D printing as a keychain and thought you guys might like to see the results. I've ordered it and it should arrive in a few weeks. It was a pretty fun process, and wasn't too difficult. I used Autodesk's free programs Meshmixer and 123d Design. If it turns out well, I might try to make some more.
Thanked by: Mystie, Rosencrantz, psychospacecow
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
3D Printing - by Rho - 08-23-2014, 08:43 PM
RE: 3D Printing - by Mystie - 08-23-2014, 10:12 PM
RE: 3D Printing - by Rosencrantz - 08-24-2014, 02:01 AM
RE: 3D Printing - by Rho - 08-24-2014, 03:35 PM
RE: 3D Printing - by Raccoon Sam - 08-26-2014, 11:34 AM
RE: 3D Printing - by Rho - 08-26-2014, 02:58 PM
RE: 3D Printing - by SmithyGCN - 08-26-2014, 08:48 PM
RE: 3D Printing - by Raccoon Sam - 08-27-2014, 03:11 AM
RE: 3D Printing - by PurplePixel - 08-30-2014, 12:36 AM
RE: 3D Printing - by Raccoon Sam - 08-30-2014, 02:34 PM
RE: 3D Printing - by PurplePixel - 08-30-2014, 06:51 PM
RE: 3D Printing - by NICKtendo DS - 08-30-2014, 03:27 PM
|
