How do you rip Models

[Shadowth117]

I've decided to try and do some model rips from Digimon World Data Squad for kicks, (amusingly, to my surprise someone has already gone and figured out how to get to the model data manually), but, much to my shock and annoyance, neither 3D Ripper DX or 3D Via Printscreen work with PCSX2. And by "don't work" I mean none of the hotkeys I've tried even make them start ripping. And I've confirmed that both work with other Direct X programs.

Then again, considering how the game's data is stored, and that I hear it's an utter pain to rip PS2 models properly at the moment, it would probably be easier to just figure out how to get the models out of FS.Bin, really (and more beneficial, if you can get animations as well). Maybe. (Not exactly an expert on the subject.)

Edit: You know, I wasn't entirely sure if this was the best thread to post this, to be honest...

Meh, its fine posting it here. We're pretty loose with that honestly.

As for ripping them from the file, you may be able to figure out a bit from here: http://ps23dformat.wikispaces.com/ , but it might just be easier to use 3D Via or 3D Ripper as you'd mentioned you'd tried. The most obvious issue I can think of is that you're using Direct X 10 rather than 9 in your graphics plugin, but if you're already aware of that than there's nothing obvious that I could guess without a look at your settings. Also, it'd be best to make sure you don't have any hotkeys assigned for ripping that are used for something in PCSX2 because that could cause problems as well.